The TRASKO C-TOOL is our special Heavy Duty Disk Pad Spreader. An excellent combined tool for working on Front & Rear Disk Brakes. Fabricated in SS-304 Material. And built to last for a lifetime. The tool construction has 5" torque handle, with a 5" drive shaft 1.0" diameter push disk and a 3" stopping pad. The disk moves 1/8" per turn. Reduces time and effort in retracting the brake piston back into its caliper housing. The tool gives you precision and enhances safety while changing brake pads. An efficient tool for $39.95, works on Cars and Pick-Up Trucks. It works both on single piston front disk calipers, . The tool protects your bushings and prevents from damage being done while replacing the pads. When working on dual piston place an old pad in between the pistons and use the tool. (Note: when you tighten the nut, it is used for rear piston, on big trucks and cars)
(Remove
the reservoir cap when using the tool)
JUST TIGHTEN THE NUT AND
USE IT TO RETRACT THE REAR PISTON INTO THE CALIPER
(C-TOOL-1)
THE TOOL BELOW IS FOR WORKING ON CALIPERS WITHOUT A SLOT.
Made in SS-304 Steel, Made to built a lifetime.
(C-TOOL-2)
Questions? Comments? Contact us at:
(904) 381-8229 Mon.-Fri., 8:00 a.m. to 4:00 p.m. EST
(904) 378-4421 Mon.-Fri., 3:00 p.m. to 6:00 p.m. PST
Email: sales@trasko-usa.com
to order: CLICK HERE
Think Ahead: Think Right:
Install a TRASKO!
©2002 Trasko-USA, Trasko-Bee
Corp, Trasko Korea Co. Ltd. All rights reserved.