INSTRUCTIONS ON REPLACING THE FILTER CARTRIDGE FOR OUR NEW STAINLESS STEEL 10SS FILTER

NOTE: TIGHTEN THE TOP VALVE UNTIL IT CANNOT TURN ANYMORE, I.E EXTREMELY TIGHT
THE FILTER COMES WITH A CARTRIDGE IN IT, IT IS READY TO BE INSTALLED. 1). TO CHANGE CARTRIDGE FIRST REMOVE THE TOP GASKET.
2). LOOSEN THE BY-PASS VALVE WITH THE WRENCH PROVIDED. 3.) AFTER LOOSENING ROTATE THE NUT ANTI-CLOCKWISE TO REMOVE IT.
4). USING THE CLAW END CAREFULLY PULL THE COVER, DO NOT DAMAGE IT. 5). THIS IS HOW THE COVER COMES OUT. USE YOUR FINGERS IF YOU CAN TO REMOVE THE COVER.
6). PULL THE BY-PASS MESH OUT USING YOUR FINGERS. JUST GIVE IT A LITTLE TICK TO CLEAN IT, YOU DO NOT NEED TO WASH IT. 7). THIS IS HOW IT LOOKS, WITH THE MESH OUT, THE CARTRIDGE IS NOW EXPOSED.  WHEN THE FILTER IS USED, THE CARTRIDGE IS FULL OF OIL. AND SLIPS OUT EASILY, SIMPLY BY OVERTURNING IT.
8) IF NOT, THEN LOOK INSIDE THE FILTER, THERE IS A SLOT, IN IT. INSERT THE CLAW END OF THE WRENCH ALL THE WAY AT THE BOTTOM, INTO THE SLOT AND PULL IT OUT.  THE CARTRIDGE COMES OUT. 9) ONCE THE CARTRIDGE IS OUT, JUST USE YOUR FINGERS TO COMPLETELY REMOVE THE CARTRIDGE.  INSERT A NEW CARTRIDGE, AFTER EVERY 10,000 MILES.
10) REMOVE THE INSIDE ORING OF THE COVER, EVERYTIME YOU CHANGE THE CARTRIDGE. 11) REPLACE IT WITH A NEW ORING.