Relocation-Engine Mount: This part screws on to the engine where the filter goes on.  It COMES with 2 EXXON hoses fitted to the mount. A thick neoprene gasket is provided that seals on to the engine.  The hoses are 6 feet long-1/2" ID, have a max SAE hydraulic operating pressure of 250 psi and 800 Deg Fahrenheit temperature resistance.  It is tightened 3/4 turn just as the stock oil filter with a ring wrench. 

(Caution: do not   tighten with a wrench holding the hose nipple ends, use only a ring wrench to make that extra 3/4 turn)  

Relocation-Remote Mount: This part is bolted on to the vehicles fire wall or any convenient spot.  Use a good judgment to find a spot within the vehicle.  Keep in mind when installing this part, it serves best to find the shortest distance possible and away from the engine.  There are two holes provided to insert 1/4" diameter metal screws with spring washers.  (Tighten until the spring washers look flat, do not over-tighten or you may rip the threads or the nut . An illustration is shown below , how this remote mount looks upon installation)

OUR MOUNT PROVIDES LEAST RESTRICTIVE OIL FLOW

Remote Mount:

Showing Stock Filter

Remote Mount :

TMR-10S, Trasko Filter installed

THE REMOTE MOUNT IS MACHINED

FROM ONE SINGLE ALUMINUM BLOCK, COMES WITH 1/2"-NPT NIPPLES INSTALLED AND HAS AN AUXILARY PORT FOR ATTACHING AN ADDITIONAL HOSE

Remote Mount  installed on the fire wall:  Stock Filter Installed

THE ENGINE MOUNT COMES WITH 1/2"-NPT NIPPLES INSTALLED.

Kit completely assembled

Ideal for making easy oil changes